Occidental Leather Tool Sleeves & Sheaths

Occidental Leather 5114K Key Features

• Low profile sleeve keeps tool snug to the body
• DIY install kit with copper rivets and instructions
• Premium leather construction, handcrafted
• Made in the USA

Occidental Leather 5114K Applications

• Framing and structural carpentry carry
• Roofing tasks requiring secure pry bar access
• Finish carpentry and trim work
• Mounting to tool pouches, vests, or belt rigs

Occidental Leather 5114K Installation Overview

1. Gather tools: smooth face hammer, side cutters, 9/32 deep socket, pick, drill with 3/16 bit, and a hard surface.
2. Drill out and remove the two outer rivets on the nondominant side bag.
3. Position sleeve; push a new rivet through the hanger and sleeve holes.
4. Seat washer using a hammer and socket or small pipe.
5. Trim excess rivet length to about 1/8 - 3/16 in.
6. Peen the rivet on a hard surface until tight; repeat for remaining rivet.

Occidental Leather B5114K Features

• Low-profile carry keeps tool snug and secure
• DIY installation with copper rivets and guidance
• Premium, handcrafted leather construction
• Made in USA

Occidental Leather B5114K Applications

• Framing work requiring fast cat's paw access
• Roofing tasks where low-swing storage is preferred
• General carpentry and trim installation
• Outfitting tool belts, vests, and rigs with a dedicated sleeve

Occidental Leather B5114K Installation Overview

1. Gather tools: smooth face hammer, cutters, 9/32 socket, pick, drill with 3/16 bit, and hard surface.
2. Drill out two outer rivets from the non-dominant side bag.
3. Insert the new rivet through the hanger and through the sleeve hole.
4. Seat washer using a hammer and socket or small pipe.
5. Trim rivet to leave about 1/8 to 3/16 length.
6. Peen rivet on a hard surface with a smooth face hammer to finish.